EV Control System

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

- Turn power switch OFF and wait at least 20 seconds.
- Make sure that 12V battery voltage is 11 V or more.
- GO TO 2.

2. DTC REPRODUCTION PROCEDURE

With CONSULT
1.Turn power switch ON and wait at least 5 seconds.
2.Check self-diagnostic result.
Is DTC detected?
YES - Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. PERFORM DTC CONFIRMATION PROCEDURE AGAIN

With CONSULT
1.Turn power switch ON.
2.Erase self-diagnostic result.
3.Perform DTC confirmation procedure again. Refer to "DTC Logic" .
4.Check self-diagnostic result.
Is the DTC detected again?
YES- Replace VCM. Refer to "Removal and Installation" Removal And Installation.
NO- INSPECTION END