Vehicle Charging System

Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2
communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.


DTC Logic


DTC DETECTION LOGIC







DTC REPRODUCTION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn power switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. CHECK DTC DETECTION

With CONSULT
1.Turn the power switch OFF to ON.

CAUTION:
Never engage READY state.
2.Repeat step 1 two or more times.

CAUTION:
Be sure to wait for 5 seconds or more after turning the power switch OFF.
3.Turn the power switch OFF.
4.Get out of the vehicle, close all doors (including back door), and wait for 3 minutes or more.
5.Turn the power switch ON.

CAUTION:
Never engage READY state.
6.Erase self-diagnosis result of "BRAKE".

CAUTION:
After erasing self-diagnosis results, turn the power switch OFF, get out of the vehicle, close all doors (including back door), and wait for 3 minutes or more.
7.Depress brake pedal by 100 mm (3.94 in) or more, and hold the position for 5 seconds or more.
8.Release brake pedal.
9.Repeat steps 7 to 8 three times.
10.Perform "BRAKE" self-diagnosis.
Is DTC "U1010" detected?
YES- Proceed to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK SELF-DIAGNOSIS RESULTS

Check for failures in the pin terminals and connections of the electrically-driven intelligent brake unit harness connector.
Is the inspection result normal?
YES- Replace the electrically-driven intelligent brake unit. Refer to "Removal and installation" Removal And Installation.
NO- Repair or replace error-detected parts.