Electric Shift

U1010 CONTROL UNIT (CAN)

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, power switch OFF and wait for at least
10 seconds, then perform the next test.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT
1.Power switch OFF to ON and wait for 5 seconds or more.
2.Check DTC.
Is "U1010" detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. REPLACE ELECTRIC SHIFT CONTROL MODULE

Replace the electric shift control module. Refer to "Removal and Installation" Removal And Installation.
- END