Parking Brake System: Service and Repair

PARKING BRAKE SYSTEM

Inspection and Adjustment


INSPECTION

Inspect Components
- Check each component for installation condition such as looseness.
- Check the cables and parking brake actuator for wear, damage and cracks. Replace if necessary.

ADJUSTMENT

1.Adjust the adjust nut. Refer to "Removal and Installation" Removal And Installation.
2.Remove rear tires with power tool.
3.Fix the disc rotor using wheel nut.





4.Remove the adjusting hole plug from the disc rotor. Turn the adjuster (1) in the direction (A) as shown in the figure using a suitable tool until the disc rotor is locked.
5.Turn back the adjuster 7 notches from the locked position.
6.Rotate the disc rotor to check that there is no drag. Install the adjuster hole plug. Refer to "Inspection and Adjustment" Inspection.
7.Perform parking brake actuator 0 point learning. Refer to "Work Procedure" Work Procedure.