Work Procedure

INSPECTION AND ADJUSTMENT

SOFTWARE UPDATE (AV CONTROL UNIT) : Work Procedure


1. START OF CONFIRMATION/ADJUSTMENT MODE

1.Set the power switch on ACC.
2.With AUDIO OFF, press "MAP" switch three times, ""switch twice, and press "MAP" switch once to start the On Board Diagnosis Function.





3.Select "Software Update" in Confirmation/Adjustment mode.
- GO TO 2.






2. UPDATE THE SOFTWARE OF THE AV CONTROL UNIT

1."Please insert SD Card for the program update and Push OK
button" pops up.





2.Press the OPEN/TILT switch of the AV control unit to open the display.
3.Remove the cover of the SD slot and insert the SD card for software update into the SD card sub-slot (on the left).
NOTE:
Leave the map SD card inserted in the main slot (on the right).
4.Press the OPEN/TILT switch of the AV control unit to close the display.
5.Select "OK" in the pop-up confirmation to start software update.
NOTE:
The instructions below must be followed during software update.
- Never turn the power switch OFF.
- Never remove the SD card.





- Never use other functions. They are not available.
6.When the software update is complete, "The update of the program completed successfully. Please switch the power off and on again to reboot." is shown.
7.Press the OPEN/TILT switch of the AV control unit to open the display.
8.Remove the SD card for software update from the SD card sub-slot (on the left) and install the cover of the
SD slot.
9.Turn the power switch OFF.
- GO TO 3.

3. CHECK THE UPDATED SOFTWARE VERSION OF THE AV CONTROL UNIT

1.Set the power switch on ACC after a lapse of 15 seconds or more after the power switch is turned OFF.
2.With AUDIO OFF, press "MAP" switch three times, ""switch twice, and press "MAP" switch once to start the On Board Diagnosis Function.
3.Select "Version Information" in Confirmation/Adjustment mode.
4.Check version information to see that the Boot ware and the application version are updated.





- End of program.