Transmission: Testing and Inspection

ELECTRIC SHIFT WARNING LAMP

Component Function Check


1. CHECK ELECTRIC SHIFT WARNING LAMP

Check that electric shift warning lamp turns ON for approx. 2 seconds after power switch is ON.
Is the inspection result normal?
YES- INSPECTION END
NO- Go to "Diagnosis Procedure" .


Diagnosis Procedure


1. CHECK DTC OF ELECTRIC SHIFT CONTROL MODULE

With CONSULT
1.Power switch ON.
2.Perform "Self Diagnostic Results" in "SHIFT".
Is any DTC detected?
YES- Check DTC detected item. Refer to "DTC Index".
NO- GO TO 2.

2. CHECK DTC OF VCM

With CONSULT
1.Power switch ON.
2.Perform "Self Diagnostic Results" in "EV/HEV".
Is any DTC detected?
YES- Check DTC detected item.
NO- 1.Check input/output signals of VCM. Refer to "Reference Value" VCM.
2.If inspection result is OK, GO TO 3.

3. CHECK DTC OF COMBINATION METER

With CONSULT
1.Power switch ON.
2.Perform "Self Diagnostic Results" in "METER".
Is any DTC detected?
YES- Check DTC detected item.
NO- 1.Check input/output signals of combination meter. Refer to "Reference Value" Combination Meter.
2.If inspection result is OK, GO TO 4.

4. CHECK HARNESS BETWEEN VCM AND COMBINATION METER

1.Disconnect the combination meter connector.
2.Disconnect the VCM connector.
3.Check the continuity between combination meter vehicle side harness connector terminal and VCM vehicle side harness connector terminal.





4.Check the continuity between combination meter vehicle side harness connector terminal and ground.





Is the inspection result normal?
YES- INSPECTION END
NO- Repair or replace damaged parts.