C1710

C1708 - C1711 Data From Transmitter Not Being Received


Description

Tire pressure data for one or more transmitters is not being received by the BCM.


DTC Logic

NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
- Activate and display TPMS transmitter IDs
- Display tire pressure reported by the TPMS transmitter
- Read TPMS DTCs
- Register TPMS transmitter IDs

DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. ID REGISTRATION AND VEHICLE DRIVING

1.Carry out ID registration of all transmitters. ID Registration Procedure.
2.Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for
10 minutes.
3.Check all tire pressures with CONSULT within 5 minutes.
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES- Inspection End.
NO- .


Diagnosis Procedure

NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
- Activate and display TPMS transmitter IDs
- Display tire pressure reported by the TPMS transmitter
- Read TPMS DTCs
- Register TPMS transmitter IDs

1. CHECK BCM

Drive for several minutes. Check all tire pressures with CONSULT.
Are all tire pressures displayed as 0 kPa?
YES- GO TO 2
NO- GO TO 3

2. CHECK TIRE PRESSURE RECEIVER CONNECTOR

Check tire pressure receiver connector for damage or loose connections.
Is the inspection result normal?
YES- Replace BCM, then GO TO 3. Service and Repair.
NO- Repair or replace tire pressure receiver connector.

3. PERFORM ID REGISTRATION

Carry out ID registration of all transmitters. ID Registration Procedure.
Is there a tire that cannot register ID?
YES- Replace malfunctioning transmitter, then GO TO 5. Service and Repair.
NO- GO TO 4

4. DRIVE VEHICLE

1.Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
2.Check all tire pressures with CONSULT within 15 minutes after vehicle speed becomes 17 km/h (11
MPH).
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES- Inspection End.
NO- GO TO 5

5. ID REGISTRATION AND VEHICLE DRIVING

1.Carry out ID registration of all transmitters. ID Registration Procedure.
2.Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for
10 minutes.
3.Check all tire pressures with CONSULT within 5 minutes.
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES- Inspection End.
NO- Proceed to the inspection applicable to DTC.


Special Repair Requirement

Perform preliminary check. Preliminary Check.