Control Module HVAC: Service and Repair

Electronic Climate Control Programmer Location:

Electronic Climate Control Programmer Vacuum Harness:

Electronic Climate Control Programmer Internal Components:

REMOVE OR DISCONNECT
1. Negative battery cable.
2. R.H. sound insulator.
3. Center I.P. trim plate.
4. Lower I.P. trim plate.
5. Wiring and hoses from programmer.
6. Programmer linkage cover and linkage.
7. Speaker grille and speaker to reach rear bolt attaching programmer to tempmatic module.
8. Programmer and disconnect any wiring still attached to programmer.
9. Buffer assembly if equipped.

INSTALL OR CONNECT
1. Buffer to programmer if equipped.
2. Programmer and attach wiring and hoses.
3. Speaker grille and speaker.
4. Programmer linkage and linkage cover.
5. Lower I.P. trim plate.
6. Center I.P. trim plate.
7. R.H. sound insulator.
8. Negative battery cable.