Radio/Stereo: Service and Repair
LESS CRT
1. Disconnect battery ground cable.
2. Remove screws securing instrument cluster bezel, then pull bezel away from instrument panel to disengage retaining clips.
3. Disconnect electrical connectors and remove cluster bezel.
4. Remove screws securing ECC panel and radio brackets to instrument panel and pull assembly away from panel.
5. Disconnect electrical connectors, noting position for installation, then remove ECC panel and radio assembly.
6. Remove nuts securing Radio to brackets, then the radio.
7. Reverse procedure to install.
Console Mounted Tape Player & Booster
1. Disconnect battery ground cable, then carefully pull trim plate from console.
2. Lift out shift indicator assembly and disconnect bulbs from indicator.
3. Remove screws securing console mounting plate.
4. Disconnect electrical connectors and remove mounting plate assembly.
5. Remove nuts securing tape player or booster to mounting plate and remove components as required.
6. Reverse procedure to install, pressing console trim plate into retaining clip until trim plate is secured.
WITH CRT
1. Disconnect battery ground cable.
2. Pull shift indicator trim plate up and out slowly. Place selector in neutral if necessary.
3. Remove indicator lamp bulbs.
4. Remove lumbar/bolster control switch, if equipped.
5. Remove outer console trim plate.
6. Remove attaching screws securing graphic equalizer and tape mounting plate.
7. Remove mounting plate.
8. Disconnect electrical connector from tape deck and graphic equalizer.
9. Pull tape holder out of console bucket.
10. Remove screws at bottom of console compartment liner and screws at top of liner, then pull liner out.
11. Remove nuts attaching console to floor pan.
12. Pull console upward and slide back toward rear seat.
13. Pull radio remote chassis out to the right.
14. Disconnect radio chassis electrical connectors.
15. Reverse procedure to install.