DTC 45
45 RIGHT FRONT CHANNEL WILL NOT MOVEDTC 45 Right Front Channel Will Not Move:
DTC 45 Right Front Channel Will Not Move:
Circuit Description:
This DTC is designed to detect bound-up ESB, a stuck ABS motor, or a seized hydraulic modulator. When the release is commanded during initialization, the ESB should release the ABS motor, resulting in sensed current being less than commanded current (motor is spinning freely). If the ABS motor is not moving, sensed current will be equal to stall current.
DTC Will Set When:
DTC 45 can be set during normal operation. If the EBCM detects a condition in which it cannot move the motor in either direction, a malfunction exists.
Action Taken:
This malfunction indicates the channel cannot be moved properly. A malfunction DTC is stored, ABS is disabled and the amber ABS warning lamp is turned
DTC Chart Test Description:
Number(s) below refer to circled number(s) on the diagnostic chart.
1. Ensures that proper motor circuits are located in the proper connector cavities.
2. Checks for proper ABS motor movement during apply and release commands from the Tech 1.
3. Compares EBCM command current to ABS motor feedback current.
4. Checks for a short between CKT 1282 and CKT 1283.
5. Checks for an ABS motor that is internally shorted.
6. Checks to see if malfunction is due to poor terminal contact or the EBCM.
7. Verifies that the motor can actually apply when commanded.
8. Checks for proper hydraulic modulator gear and piston movement.
Diagnostic Aids:
An "Intermittent" malfunction in this DTC may result from a mechanical part of the system that sticks, binds, or slips.
The frequency of the malfunction can be checked by using the enhanced diagnostic function of the Tech 1.
DTC 45 may set after modulator disassembly if the modulator pistons are positioned at the bottom of their bore.
Any circuitry that is suspected of causing the intermittent complaint should be thoroughly checked for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, poor terminal to wiring connections or physical damage to the wiring harness.