Brake Pedal Switches Replacement

Installing Brake Pedal Switches:

STOPLAMP/BTSI SWITCH (LOWER)
REMOVE OR DISCONNECT
1. I/P sound insulators, as needed for access.
2. Lower switch, twist counterclockwise to unlock and pull out of retainer.
3. Electrical connectors from switch.

TCC/ABS SWITCH (UPPER)
REMOVE OR DISCONNECT
1. Upper switch, twist counterclockwise to unlock and pull out of retainer.
2. Electrical connectors from switch.

INSTALL OR CONNECT

NOTE: When installing the brake pedal switches it is very important that the brake pedal remain in the full up or at rest position when installing the brake pedal switches, or damage to the brake system and or switch misadjustment may occur. Connect switch and install it. Make all connections before installing. Be sure all connectors are firmly seated and locked. When pressing switch into retainer, Do Not apply a sideload to the switch.

TCC/ABS SWITCH (UPPER)
Slide switch (with all connections made) into retainer. Press switch in until switch plunger is fully depressed into switch barrel. Twist switch clockwise until travel stop has been reached (Approximately 60�). With switch fully locked, the electrical connector will face the 3 o'clock position.

STOPLAMP/BTSI SWITCH (LOWER)
Slide switch (with all connections made) into retainer. Press switch in until switch plunger is fully depressed into- switch barrel. Twist switch clockwise until travel stop has been reached (Approximately 60�). With switch fully locked, the electrical connector will face the 3 o'clock position.