Avoid Damage to Electrical Equipment

IMPORTANT: To avoid damage to the electrical equipment, observe the following precautions:
- Do not reverse the connections to the generator.
- Do not short across, or ground any of the terminals in the charging circuit, except as directed by the instructions.
- Do not attempt to hot wire the generator by connecting B+ voltage to any of the generator 4-way connector terminals. Use only an approved test harness as described in these instructions.
- Never disconnect the output terminal while the generator is operating.
- Use only approved Metri-pack terminal probe adapters to connect the meter leads and the jumper wires to the connector terminals. Using improper adapters will damage the concrete terminals and cause charging system or test harness failure.
- Before connecting a charger or a booster battery to the vehicle battery, refer to Battery Charging.