Acceleration Sensor: Service and Repair

REMOVAL PROCEDURE
1. Move the drivers seat forward.
2. Cut the carpet back under the drivers seat to expose the lateral accelerator switch.
3. Disconnect the electrical connector from the lateral accelerator switch.
4. Remove the two screws and the lateral accelerator switch.

INSTALLATION PROCEDURE

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Install the lateral accelerator switch with two screws.
2. Connect the electrical connector to the module.
3. Install the carpet.