Scan Button
The SCAN push-button is a momentary type control that is shared with the preset scan feature. To use the scan button, refer to the following steps:^ Pressing the button will immediately mute the audio.
^ Releasing the button within 2 seconds causes the frequency to increase until a signal of sufficient strength enables stopping.
^ After stopping, the sound returns for 5 seconds, then mutes again and continues scanning.
^ If you press any of the 5 preset buttons while scanning, the scanning action will cease and the receiver will tune to the frequency of that preset.
^ If you adjust the TUNE control while scanning, the scanning action will cease and the frequency will change from the preset scanned frequency.