Oil Pump Replacement

REMOVAL PROCEDURE
1. Remove the engine front cover.





2. Remove the oil pump assembly retaining bolts identified by the larger head size.
3. Remove the oil pump assembly with the drive collar in place.
4. Inspect the oil pump.

INSTALLATION PROCEDURE
1. Install the oil pump drive spacer into the oil pump so that the drive flat engages the pump rotor.
2. Position the oil pump on the crankshaft.





3. Install the retaining bolts.

Notice: Refer to Fastener Notice in Service Precautions.

4. Apply upward pressure on the pump while tightening the three retaining bolts. Tighten the bolts in a counter clockwise pattern starting with the lower left bolt when facing the pump.
4.1. Tighten the oil pump mounting bolts in sequence to 10 Nm + 35 degrees (89 inch lbs. + 35 degrees).
4.2. Tighten the oil pump mounting bolts in sequence to 26 Nm (19 ft. lbs.).

5. Install the engine front cover.