Flash-to-Pass

Battery positive voltage (B+) is applied through the engine compartment fuse block FOG LAMP fuse via CKT 42 (RED) at all times to the headlamp dimmer switch. When the multi-function lever (turn signal) is pulled towards the driver, battery positive voltage (B+) is applied through the headlamp dimmer switch to the high beam headlamps via CKT 11 (LT GRN). If the headlamps are oft, pulling the lever will turn the high beam headlamps on for as long as the lever is held. Releasing the lever turns the headlamps off. If the low beam headlamps are on when the lever is pulled, the headlamps switch to the high beams.

The high beams remain on until the lever is pulled again. If the high beam headlamps are on when the lever is pulled, the headlamps switch to the low beams. The low beams remain on until the lever is pulled again.