Installation Procedure
Installation ProcedureNotice: Refer to Fastener Notice in Cautions and Notices..
1. Install the dual retractor and lower anchor bolt.
Tighten
Tighten the anchor bolt to 41 N.m (30 lb ft).
2. Install the intermediate guide and screw.
Tighten
Tighten the screw to 2 N.m (17 lb in).
3. Install the upper center pillar trim.
4. Install the guide loop and the anchor bolt.
Tighten
Tighten the anchor bolt to 41 N.m (30 lb ft).
5. Install the lower center pillar trim.