SIR Steering Wheel Module Coil - Disassemble

DISASSEMBLY PROCEDURE

Notice: Before performing the following procedures, check the fused jumper assembly for burnt 2 amp fuses.





1. Remove the upper and lower covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle.
2. Remove the SIR coil from the jumper assembly connector.





3. Pop the wire harness assembly out of the wire harness strap (1).





4. Remove the retaining ring (1).
5. Remove the SIR coil assembly (2).
6. Remove the wave washer (3).