Air Bag Systems: Service Precautions
WARNINGS:^ In order to avoid deploying the air bag when troubleshooting the SIR system, use only the equipment specified and the instructions given. Failure to use the specified equipment as instructed could cause air bag deployment, personal injury to you or someone else, or unnecessary SIR system repairs.
^ If any water enters the vehicle's interior up to the level of the carpet or higher and soaks the carpet, the Sensing and Diagnostic Module (SDM) and the SDM harness connector may need to be replaced. The SDM could be activated when powered, which could cause deployment of the air bag(s) and result in personal injury. Before attempting these procedures, the SIR system must be disabled. Refer to Disabling the SIR System. With the ignition OFF, inspect the SDM mounting area, including the carpet. If any significant soaking or evidence of significant soaking is detected, you must perform the following steps:
^ Remove all water.
^ Repair the water damage.
^ Replace the SDM harness connector.
^ Replace the SDM.
Failure to follow these procedures could result in possible air bag deployment, personal injury, or otherwise unneeded SIR system repairs.
^ Proper operation of the Supplemental Inflatable Restraint (SIR) Sensing System requires that any repairs to the vehicle structure return the vehicle structure to the original production configuration. Not properly repairing the vehicle structure could cause non-deployment of the air bag(s) in a frontal collision or deployment of the air bag(s) for conditions less severe than intended.
^ Proper operation of the Supplemental Inflatable Restraint (SIR) Sensing System requires that any repairs to the vehicle structure return the vehicle structure to the original production configuration. Not properly repairing the vehicle structure could cause non-deployment of the Side Impact Air Bag(s) in a side impact collision or deployment of the Side Impact Air Bag(s) for conditions less severe than intended.