Fog/Driving Lamp: Service and Repair

REMOVAL PROCEDURE
1. Remove the electrical connector from the fog lamp (4).
2. Remove the bolts (3) that retain the fog lamp (2) to the impact bar (1).
3. Remove the fog lamp (2).

INSTALLATION PROCEDURE
1. Install the fog lamp (2) to the impact bar (1).

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the bolts (3) in order to retain the fog lamp (2) to the impact bar (1).

Tighten
Tighten the bolts (3) to 3.2 N.m (28 lb in).

3. Install the electrical connector to the fog lamp (4).