Programming Features - Memory Seats - With RPO A43

When a keyless entry transmitter is used to unlock the vehicle's doors, the remote function actuator (RFA) module communicates the unlock command and which driver performed the command to the memory seat/mirror module via CKT 1985 (PPL). Each keyless entry transmitter is programmed with one of 4 personalized recall options when the RFA receives an unlock message:
^ Mode 0: The memory seat/mirror module sounds a single beep and the left seat will not move.
^ Mode 1: The memory seat/mirror module sounds a single beep and the left seat and both mirrors will move to the position stored for DRIVER-1.
^ Mode 2: The memory seat/mirror module sounds a single beep and the left seat and both mirrors will move to the position stored for DRIVER-2.
^ Mode 3: The memory seat/mirror module sounds a single beep and the left seat will move to the easy exit position which is fully back and down.

Perform the following procedure in order to program a keyless entry transmitter for a specific mode:
^ Mode 0: Press the SET MEMORY button on the left seat switch. Within 5 seconds, press the UNLOCK button on the keyless entry transmitter.
^ Mode 1: Perform a memory set function for DRIVER-1. Within 5 seconds, press the UNLOCK button on the keyless entry transmitter.
^ Mode 2: Perform a memory set function for DRIVER-2. Within 5 seconds, press the UNLOCK button on the keyless entry transmitter.
^ Mode 3: Perform one of the two following procedures in order to set the keyless entry transmitter to this mode:
^ Perform an easy exit function. Within 5 seconds, press the UNLOCK button on the keyless entry transmitter.
^ Press the UNLOCK button on the keyless entry transmitter. Within 5 seconds, press the DRIVER-1 and DRIVER-2 buttons simultaneously.