C1242

CIRCUIT DESCRIPTION
The BPMV pump motor ground is supplied through a ground stud on the pump motor to a good ground.

CONDITIONS FOR SETTING THE DTC
All of the following conditions occur:
^ The pump relay is commanded OFF.
^ The pump motor ground resistance is greater than 6900 ohms.

ACTION TAKEN WHEN THE DTC SETS
^ A malfunction DTC is stored.
^ The ABS/TCS is disabled.
^ The ABS indicator is turned ON.
^ The TRACTION OFF indicator is turned ON.

CONDITIONS FOR CLEARING THE DTC
^ The condition for the DTC is no longer present and you used the scan tool Clear DTC function.
^ The EBCM/EBTCM does not detect the DTC in 50 drive cycles.

DIAGNOSTIC AIDS
^ It is very important that a thorough inspection of the wiring and connectors be performed. Failure to carefully and fully inspect wiring and connectors may result in misdiagnosis, causing part replacement with reappearance of the malfunction.
^ An intermittent malfunction can be caused by poor connections, broken insulation, or a wire that is broken inside the insulation.
^ If an intermittent malfunction exists, refer to Intermittents and Poor Connections Diagnosis in Diagnostic Information and Procedures.

TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table.
2. This step checks for a good pump motor ground.
4. This step checks for proper pump motor resistance.