Emblem/Nameplate Replacement (Aurora)

Emblem/Nameplate Replacement (Aurora)

Nameplate Procedure




1. Wash the affected panel with a soap and water mixture.
2. Dry the affected panel using a clean cloth.
3. Remove all traces of adhesive from the rear deck lid (1) and from the back of the emblem/nameplate (2) using 3M General Purpose Adhesive Cleaner 08984 or equivalent.
4. Wipe the panel with a clean cloth and an alcohol and water mixture.




5. If the body is below 21°C (70°F), warm the affected panel with a heat lamp or a heat gun while proceeding with the following step.

Important: Care should be exercised not to touch the tape with your hands or allow the adhesive tape to come in contact with any dirt or foreign matter.


6. Peel the backing from the adhesive tape.
7. Using the following dimensions align the nameplate (2) to the rear compartment lid:

* 25.7 mm (+/- 2 mm) 1.01 in (+/- 0.08 in) (A) from the horizontal edge (3).
* 109.5 mm (+/-2.0 mm) 4.31 in (+/- 0.08 in) (B) from the centerline of the rear compartment lid 1.

8. Press the nameplate (2) firmly in place in order to ensure proper adhesion to the rear compartment lid.

Hood Emblem Procedure




1. Wash the affected panel with a soap and water mixture.
2. Dry the affected panel using a clean cloth.
3. Remove all traces of adhesive from the hood and from the back of the emblem (1) using 3M General Purpose Adhesive Cleaner 08984 or equivalent.
4. Wipe the hood with a clean cloth and an alcohol and water mixture.




5. If the body is below 21°C (70°F), warm the affected panel with a heat lamp or a heat gun while proceeding with the following steps.

Important: Care should be exercised not to touch the tape with your hands or allow the adhesive tape to come in contact with any dirt or foreign matter.


6. Peel the backing from the adhesive tape.
7. Using the following dimensions align the emblem to the hood:

* 70.0 mm (+/- 2 mm) 2.76 in (+/- 0.08 in) A from the front edge of the hood (1).
* 43.5 mm (+/-2.0 mm) 1.71 in (+/- 0.08 in) B from the centerline of the hood 1.

8. Press the emblem firmly in place in order to ensure proper adhesion to the hood.