Closeout/Insulator Panel Replacement - Right

Instrument Panel Insulator Panel Replacement - Right Side

Removal Procedure




1. Remove the fasteners securing the closeout insulator panel (3) to the instrument panel retainer.
2. Remove the push in retainer in order to release the closeout insulator panel from the IP retainer.
3. Turn the heater temperature sensor (2) 1/4 counter clockwise in order to remove the sensor from the closeout insulator panel (3).
4. Disconnect the electrical connector (1) from the lower IP courtesy lamp.
5. Slide the closeout insulator panel rearward in order to remove from the vehicle.

Installation Procedure




1. Set the forward edge of the insulator onto the shelf of the dash mat.
2. Install the heater temperature sensor (2) into the closeout insulator panel (3) by turning 1/4 turn clockwise.
3. Connect the electrical connector (1) to the lower IP courtesy lamp.
4. Position the closeout insulator panel (3) to the IP retainer.

Notice: Refer to Fastener Notice in Cautions and Notices.

5. Install the fasteners in order to secure the close out insulator panel to the IP retainer.

Tighten the fasteners to 2 Nm (18 lb in).

6. Install the push in fastener in order to secure the closeout insulator panel to the IP retainer.