Instrument Panel Cluster (IPC) - Trim Plate Bezel Replacement

Instrument Panel Cluster Trim Plate Bezel Replacement

Removal Procedure

1. Lower the tilt steering column to the lowest position.




2. Pry out the ignition cylinder bezel (1).
3. Remove the left I/P outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement (Instrument Panel (IP) - Outer Trim Cover Replacement).
4. Remove the I/P center trim plate. Refer to Instrument Panel Center Trim Panel Replacement (Instrument Panel Center Trim Panel Replacement).
5. Remove the driver side knee bolster. Refer to Knee Bolster Replacement (Service and Repair).
6. Remove the right I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side (Instrument Panel (IP) - Accessory Trim Plate Replacement - Right Side).




7. Remove the push pin fasteners that retain the top trim cover to the I/P cluster.
8. Remove the left I/P air deflector. Refer to Instrument Panel Outer Air Outlet Deflector Replacement - Left Side in Heating, Ventilation, and Air Conditioning.




9. Remove the fasteners that retain the trim plate to the I/P cluster.
10. Disconnect the electrical connectors.
11. Remove the I/P cluster trim plate from the vehicle.

Installation Procedure




1. Position the I/P cluster trim plate to the vehicle.
2. Connect the electrical connectors.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the fasteners that retain the trim plate to the I/P cluster.

Tighten the fasteners to 2 Nm (18 lb in).




4. Install the top I/P cluster trim cover and the push pin fasteners.
5. Install the left I/P air outlet vent. Refer to Instrument Panel Outer Air Outlet Deflector Replacement - Left Side in Heating, Ventilation, and Air Conditioning.
6. Install the right I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side (Instrument Panel (IP) - Accessory Trim Plate Replacement - Right Side).
7. Install the driver side knee bolster. Refer to Knee Bolster Replacement (Service and Repair).
8. Install the I/P center trim plate. Refer to Instrument Panel Center Trim Panel Replacement (Instrument Panel Center Trim Panel Replacement).
9. Install the left I/P outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement (Instrument Panel (IP) - Outer Trim Cover Replacement).




10. Install the ignition cylinder bezel (1).