Driver or Passenger Seat Back Cushion Frame Replacement

Driver or Passenger Seat Back Cushion Frame Replacement

Removal Procedure

Caution: Refer to SIR Handling Caution (SIR Handling Caution) in Cautions and Notices.

1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
2. Put the seat back in the full upright position..
3. Remove the seat back cover and pad. Refer to Driver or Passenger Seat Back Cushion Cover and Pad Replacement (Driver or Passenger Seat Back Cushion Cover and Pad Replacement).
4. Remove the lumbar. Refer to Driver or Passenger Seat Lumbar Support Replacement (Power) (Driver or Passenger Seat Lumbar Support Replacement (Power)).




5. Remove the fasteners (3) retaining the seat back frame (1) to the recliner.
6. Lift straight up on the seat back frame (1) in order to disengage the seat back frame from the recliner.

Installation Procedure




1. Slide the seat back frame (1) straight down into recliner.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the seat back frame fasteners (3).

Tighten the seat back frame fasteners (3) to 28 Nm (21 lb ft).

3. Install the lumbar. Refer to Driver or Passenger Seat Lumbar Support Replacement (Power) (Driver or Passenger Seat Lumbar Support Replacement (Power)).
4. Install the seat back cover and pad. Refer to Driver or Passenger Seat Back Cushion Cover and Pad Replacement (Driver or Passenger Seat Back Cushion Cover and Pad Replacement).
5. Enable the SIR system. Refer to Enabling the SIR System in SIR.