Cruise Control Switch Replacement

REMOVAL PROCEDURE

CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.




1. Remove the steering wheel from the vehicle. Refer to Steering Wheel Replacement in Steering Wheel Column-Tilt.
2. Turn the steering wheel upside down on a clean flat surface.
3. Remove the access plate covering the back of the switch.




4. Remove the fasteners (1) retaining the switch (2) to the steering wheel.
5. Disconnect the electrical connector.

INSTALLATION PROCEDURE




1. Connect the electrical connector.
2. Position the switch (2) in the opening on the steering wheel.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the fasteners (1) to retain the switch (2) to the steering wheel.

Tighten
Tighten the fasteners (1) to 2.30 N.m (20 lb in).




4. Install the access plate.
5. Install the steering wheel. Refer to Steering Wheel Replacement in Steering Wheel Column-Tilt.