Courtesy Lamp Replacement - IP (Right Side)

REMOVAL PROCEDURE




1. Remove the fasteners (1) securing the right closeout insulator panel (3) to the instrument panel retainer.




2. Lower the closeout insulator panel (3) in order to gain access to the courtesy lamp.
3. Disconnect the electrical connector (1) from the courtesy lamp.
4. Unclip the courtesy lamp from the closeout insulator panel (3).

INSTALLATION PROCEDURE




1. Position the courtesy lamp to the opening in the closeout insulator panel (3).
2. Push inward on the courtesy lamp in order to engage the retaining clip.
3. Connect the electrical connector (1) to the courtesy lamp.




4. Position the closeout insulator panel with the instrument panel retainer.

NOTE: Refer to Fastener Notice in Service Precautions.

5. Install the closeout insulator panel fasteners (1) in order to secure the panel to the retainer.

Tighten
Tighten the fasteners to 2 N.m (18 lb in).