Turn Signal Switch: Service and Repair
Multifunction Turn Signal Lever Replacement-On VehicleRemoval Procedure
Caution: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the knee bolster.
3. Remove the steering wheel.
4. Remove the tilt lever.
5. Remove the lower screws from the lower shroud.
6. Remove the lower shroud.
- Tilt the shroud down and slide back to disengage the locking tabs.
- Remove the shroud protector.
7. Remove the screws from the upper shroud.
8. Remove the upper shroud.
9. Remove the fasteners from the multi-function switch.
10. Disconnect the multi-function switch electrical connections.
11. Remove the multi-function switch.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the multi-function switch and the fasteners.
- Tighten the fasteners to 7 Nm (62 inch lbs.).
2. Route the electrical harness and connect electrical connections.
3. Install the upper shroud and install the fasteners.
- Tighten the fasteners to 7 Nm (62 inch lbs.).
4. Install the lower shroud.
- Ensure that the slots on the lower shroud engage with the tabs on the upper shroud.
- Tilt the lower shroud up and snap the shrouds together.
5. Install the 2 fasteners.
- Tighten the fastener to 7 Nm (62 inch lbs.).
6. Install steering wheel.
7. Install tilt lever.
8. Install the knee bolster.
9. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.