Valet Switch: Service and Repair

VALET SWITCH REPLACEMENT

REMOVAL PROCEDURE




1. Remove the right IP accessory trim plate. Refer to Trim Plate Replacement - IP Accessory Right.
2. Remove the valet switch by prying down at the top to release the clips.




3. Disconnect the electrical connector.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the valet switch.




2. Install the valet switch by pressing into the IP.
3. Install the right IP accessory trim plate. Refer to Trim Plate Replacement - IP Accessory Right.
4. Close the instrument panel storage compartment.