Cruise Control Switch: Adjustments

CRUISE RELEASE SWITCH ADJUSTMENT

IMPORTANT: Do not depress the brake pedal during the adjustment procedure.




1. Insert the release switch (1) into the retainer until the switch is fully seated against the brake pedal arm.
2. Twist the switch in order to lock the switch into position.

Measure
Measure the distance from the end of the barrel on the switch to the pedal arm, ensure that the clearance is 1.5 mm to 1.7 mm (1/16 in). If the distance is not correct, perform step 1 and step 2 again.

Measure
The following pedal travel statement may be used in order to inspect for proper adjustment of the release switch:
^ Release switch assembly must be closed at 3.5 mm to 12.5 mm (1/8 in to 1/2 in) brake pedal travel, measured at the centerline of the brake pedal assembly.
^ Nominal actuation of the release assembly contacts is about 4.5 mm (3/16 in).