Front Door Window Glass: Service and Repair

Front Side Door Window Replacement

Removal Procedure




1. Lower the window to the full down position.
2. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement Service and Repair.
3. Remove the door module. Refer to Door Control Module Replacement (Service and Repair).
4. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement Service and Repair.
5. Remove the window inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement (Door Window Sealing Strip).
6. Connect a power source to the window motor and position the window half way down.
7. Loosen the window regulator to window clamps.
8. Remove the window by tilting window forward then pulling the window up and out of the door.

Installation Procedure





Important: The window regulator should be at least half way down before installing the window.


1. Install the window down into the door.
2. Locate the window into the two clamps.

Caution: Refer to Express Window Down Caution in Cautions and Notices.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Connect a power source to the window motor and run the window to the full-up position.

Tighten the window clamp fasteners to 11 Nm (98 lb in).

4. Install the window inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement (Door Window Sealing Strip).
5. Install the water deflector. Refer to Front Side Door Water Deflector Replacement Service and Repair.
6. Install the door module. Refer to Door Control Module Replacement (Service and Repair).
7. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement Service and Repair