Rear Door Window Glass: Service and Repair

Rear Side Door Window Replacement

Removal Procedure

1. Lower the window all the way down.
2. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement Service and Repair
3. Remove the door module. Refer to Door Control Module Replacement (Service and Repair).
4. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement (Service and Repair).
5. Remove the window inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement (Rear Side Door Window Inner Sealing Strip Replacement).




6. Loosen the window regulator to window clamps.
7. Remove the window by lifting up and out.

Installation Procedure




1. Install the window down into the door assembly making sure the window is in the run channels.
2. Locate the window into the two window regulator to window clamps.
3. Install the window inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement (Rear Side Door Window Inner Sealing Strip Replacement).

Notice: Refer to Fastener Notice In Cautions and Notices.

4. Connect a power source to the window motor and run the window to the full up position.

Tighten the window clamp fasteners to 11 Nm (98 lb in).

5. Install water deflector. Refer to Rear Side Door Water Deflector Replacement (Service and Repair).
6. Install the door module. Refer to Door Control Module Replacement (Service and Repair).
7. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement Service and Repair