Ignition Control Module: Service and Repair

REMOVAL PROCEDURE




1. Disconnect the electrical connector from the ignition control module (ICM).




2. Remove the cover (4) from the ignition coils (3).
3. Remove the screws (1) retaining the ICM.
4. Remove the ignition control module (2).

INSTALLATION PROCEDURE

IMPORTANT: When servicing the ignition system components, use the following recommended procedures:
^ DO NOT re-install any component that has visible signs of damage.
^ Clean all the mounting surfaces before re-installing any components.




1. Install the ignition control module (2) on the ignition coils.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the ICM retaining screws (1).

Tighten
Tighten the screws to 1.1 N.m (10 lb in).

3. Install the cover (4) on the ignition coils (3).




4. Connect the electrical connector to the ignition control module.