Amperage Draw Test

1982 MODELS
1. Run engine until it reaches operating temperature, then turn engine off.
2. Connect battery-starter tester following manufacturer's instructions.
3. Turn variable resistor control knob on tester to zero or off position.
4. Connect remote starter switch following manufacturer's instructions.
5. Crank engine just long enough to read cranking voltage on voltmeter.
6. Turn variable resistor control knob on tester until voltmeter reads cranking voltage previously noted. Amperage should be 165---180 amps on 225 and 318 cubic inch engines, or 180---200 amps on 225 (equipped with 1.8 horsepower starter).