Manual Transmission/Transaxle: Service and Repair
MODELS w/ 4-105 ENGINE1. Disconnect battery ground cable.
2. Disconnect shift linkage rods, starter wiring and back-up lamp switch wiring.
3. Remove starter and disconnect clutch cable.
4. Remove bolt attaching speedometer adapter to transaxle.
5. With speedometer cable housing connected, pull adapter and pinion from transaxle.
6. Raise and support vehicle. Also, support engine with suitable equipment.
7. Disconnect righthand drive shaft and position aside.
8. Remove lefthand drive shaft.
9. Remove left splash shield.
10. Drain transaxle fluid.
11. Remove bolts from left engine mount.
12. Remove transaxle to engine attaching nuts and bolts.
13. Slide transaxle toward left side of vehicle until mainshaft clears clutch.
14. Lower and remove transaxle from vehicle.
15. Reverse procedure to install.