Front Seat Assembly

REMOVAL STEPS
1. Cowl side trim
2. Scuff plate
3. Head restraint
4. Shield cover
5. Reclining adjuster
6. Seat back
7. Seat cushion
8. Rail cover (Sports seat only)
9. Side sill cover
10. Back bone cover
11. Seat adjuster
12. Wire


SERVICE POINTS OF REMOVAL





12. Removal Of Seat Adjuster
To remove the rear seat adjuster mounting bolts located at the rear on the inboard side, remove the floor console mounting bolts shown in the illustration and raise floor console slightly.

SERVICE POINTS OF INSTALLATION
12. Installation Of Seat Adjuster
1. Apply the specified grease to the sliding parts.

Specified grease: MOPAR Multi-mileage Lubricant Part Number 2525035 or equivalent





2. With the seat adjuster at the rearmost position and with both slide locks positively fastened, install the front seat from the front. Temporarily tighten the mounting bolts, and make sure that adjuster locks correctly on both sides during forward and backward movement. Tighten the mounting bolts to the specifications in the sequence shown in the illustration.