Accelerator Pedal - Vibration While Driving
NO: 14-12-94GROUP: Fuel
DATE: Jun. 6, 1994
SUBJECT:
Accelerator Pedal Vibration
MODELS:
1995 (PL) Neon
NOTE:
THIS BULLETIN APPLIES TO THE FOLLOWING VEHICLES:
AUTOMATIC TRANSMISSION EQUIPPED BUILT PRIOR TO MDH 04-11-XX.
MANUAL TRANSMISSION EQUIPPED BUILT PRIOR TO MDH 04-18-XX.
SYMPTOM/CONDITION:
Automatic and Manual Transmission - Vibration felt through the accelerator pedal at 3000 to 3500 RPM's while driving.
Manual Transmission - Vibration felt through the accelerator pedal at idle or low engine RPM's while driving.
DIAGNOSIS:
Using the Mopar Diagnostic System (MDS) or the Scan Tool (DRBIII) with appropriate diagnostic procedure manual, verify that all engine systems are functioning as designed. If Diagnostic Trouble Codes (DTC's) are present, record them on the repair order for future reference and repair as necessary. If no codes are present and all systems are functioning correctly, proceed with the following repair.
PARTS REQUIRED:
1 4669467 Throttle Cable Assembly - Man. Trans.
1 4669468 Throttle Cable Assembly - Auto. Trans.
REPAIR PROCEDURE:
This bulletin involves removal, replacement and rerouting of the throttle cable assembly.
1. Following the procedures outlined in the 1995 Neon Service Manual (Publication No. 81-270-5025), Pages 14-14 and 14-15, replace the throttle cable assembly with the appropriate new cable listed in the parts section of this bulletin.
NOTE:
ROUTE THE NEW THROTTLE CABLE ASSEMBLY INBOARD OF THE HEATER HOSES, UNDERNEATH THE AIR CLEANER FRESH AIR DUCT AND OVER THE TOP OF THE SPEED CONTROL CABLE.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No: 14-80-25-90 0.2 Hrs.
FAILURE CODE: P8 - New Part