Sunroof / Moonroof: Adjustments

SUNROOF GLASS HEIGHT ADJUSTMENT

Flushness
1. Position sunshade in full rearward position.
2. To adjust front of glass;
a. Loosen front and middle glass attachment screws
b. Adjust front of sunroof glass panel so that the corners are flush to 1.0 mm below the top surface of the roof panel.
c. Tighten all glass attachment screws.
3. To adjust rear of glass;
a. Loosen rear and middle glass attachment screws
b. Adjust rear of sunroof glass panel so that the corners are flush to +/- 1.0 mm off the top surface of the roof panel.
c. Tighten all glass attachment screws.

Vent Height
1. Cycle the sunroof vent glass to the vent position using the drive motor.
2. Remove the drive motor.
3. If the vent height is greater than 35 mm;
a. Manually close the sunroof mechanism so that the vent height is less than 35 mm.
b. Manually open the sunroof mechanism to achieve the correct vent height of 35 mm.
4. If the vent height is less than 35 mm, manually open the sunroof mechanism to achieve the correct vent height of 35 mm.
5. Install drive motor and verify correct operation. If necessary, repeat the above steps to obtain the correct vent height.