Manifold Pressure/Vacuum Sensor: Service and Repair

MAP/IAT Sensor:

The MAP/IAT sensor attaches to the intake manifold plenum.

REMOVAL

Air Inlet Duct:

1. Remove air inlet duct wing nut and duct from intake manifold.
2. Disconnect the electrical connector from the MAP/IAT sensor.
3. Remove sensor mounting screws.
4. Remove sensor.

INSTALLATION
1. Insert sensor into intake manifold while making sure not to damage O-ring seals.
2. Tighten mounting screws to 2 N.m (20 in. lbs) torque foe a plastic manifold and 3 N.m (30 in. lbs) for a aluminum manifold.
3. Attach electrical connector to sensor.
4. Install air inlet duct wing nut and duct from intake manifold, insure that the duct does not interfer with ignition cables.