Maintenance Inspection

1. Check that both front impact sensors are properly installed to the brackets on the frame with three fasteners each. Verify that the electrical connectors are securely fastened. Repair as required.
2. Check the airbag warning lamp for proper operation as follows:
a. Turn ignition switch to the ON position, the airbag warning lamp should light. If not, test the system using a scan tool and Passive Restraint System Diagnostic Procedures. Repair as required.
b. The airbag warning lamp lights, but fails to go out after eight seconds. Test the system using a scan tool and Passive Restraint System Diagnostic Procedures. Repair as required.
c. After correcting active malfunction erase stored diagnostic codes.