Programming and Relearning

PROGRAMMING AUTOMATIC DOOR LOCKS
The vehicle comes with two modes for power door locks:
- Rolling automatic lock, ENABLE approximately at 29 kph (18 mph).
- No rolling automatic lock, DISABLE.

CUSTOMER PROGRAMMING
1. Close all doors.
2. Cycle the ignition switch to from the OFF to RUN position four times and leaving the switch in the OFF position after the fourth cycle.
3. Press either door lock button to LOCK the doors. This procedure reverses the automatic door lock mode, Enable to Disable, or Disable to Enable. If the present mode is undesirable, repeat to arrive at the desired option. A single chime will signal programming completed.

USING A DRB III SCAN TOOL
The DRB III scan tool may also be used to Enable or Disable the automatic door lock feature under Customer Preferences.