Keyless Entry Module: Testing and Inspection
PROGRAMMING REMOTE KEYLESS ENTRY (RKE) MODULE1. Using a functional key fob transmitter, unlock the vehicle and disarm the Vehicle Theft/Security System.
2. Insert ignition key into the ignition switch.
3. Turn the ignition switch to RUN position without starting engine.
4. Using a previously programmed transmitter, press the UNLOCK button for 5 - 10 seconds. While the UNLOCK button is being pressed, press the PANIC button and then release both buttons simultaneously. You will hear a chime sound to signal you that programming on the new transmitter(s) may occur.
5. You may program up to 4 transmitters for your vehicle within a 30 second timed window. Press and release both lock and unlock buttons of a transmitter at the same time: Then press any of the buttons once, you will hear a beep when the transmitter has been successfully programmed. A chime will sound when the 30 seconds is over, or it you turn the ignition switch OFF.
6 Verify RKE system operation using each key fob.
VEHICLE ACCESS CODE (VAC) PROGRAMMING
The RKE module is capable of retaining up to four different Vehicle Access Codes. Whenever the vehicle battery power is interrupted the RKE Module will retain all vehicle access codes in its memory. When replacing or adding a key fob transmitter (maximum 4) a functional key fob transmitter is required to program the RKE Module to accept the new Vehicle Access Code. If a functional key fob transmitter is not available, a DRB III scan tool can be used to program the RKE Module. Refer to the proper Body Diagnostic Procedures for Vehicle Access Code programming procedures using a DRB III scan tool.