Handling Airbags
DEPLOYED MODULEThe vehicle interior may contain a very small amount of sodium hydroxide powder, a by-product of airbag deployment. Sodium hydroxide powder can irritate the skin, eyes, nose and throat. Wear safety glasses, rubber gloves, and long sleeved clothing when cleaning any of the powder residue from the vehicle.
If you find that the cleanup is irritating your skin, run cool water over the affected area. Also, if you experience nasal or throat irritation, exit the vehicle for fresh air until the irritation ceases. If irritation continues, see a physician.
UNDEPLOYED
The airbag modules must be stored in its original special container until used for service. At no time should a source of electricity be permitted near the inflator on the back of an airbag module. When carrying or handling an undeployed airbag module, the trim side of the airbag should be pointing away from the body to minimize possibility of injury if accidental deployment occurs. Do not place undeployed airbag face down on a solid surface, the airbag will propel into the air if accidentally deployment occurs.
MAINTENANCE INSPECTION
1. Check that both front impact sensors are properly installed to the brackets on the frame with three fasteners each. Verify that the electrical connectors are securely fastened. Repair as required.
2. Check the airbag warning lamp for proper operation as follows:
a. Turn ignition switch to the ON position, the airbag warning lamp should light. If not, test the system using a scan tool and Passive Restraint System Diagnostic Procedures. Repair as required.
b. The airbag warning lamp lights, but fails to go out after eight seconds. Test the system using a scan tool and Passive Restraint System Diagnostic Procedures. Repair as required.
c. After correcting active malfunction erase stored diagnostic codes.