Headrest and Seat Belt Web Guide
HEADREST AND SEAT BELT WEB GUIDEREMOVAL
1. Lower convertible top.
2. Move seat to the full forward position.
3. Tilt the seat back to the forward position.
Fig. 1:
4. Remove seat belt anchor bolt (Fig. 1).
5. Disengage seat belt from seat belt guide strap by turning the seat belt latch plate and anchor plate through web guide, or remove seat belt webbing through the slot on the under side of guide.
Fig. 2:
6. Unzip zippers on seat back (Fig. 2).
7. Disengage hook and loop attachment at the lower edge of seat back.
Fig. 3:
8. Disengage lower end of the clip attaching headrest to headrest post located under the seat back cover (Fig. 3).
9. Pull headrest off of seat assembly.
Fig. 4:
10. Remove seat belt guide strap by sliding the guide down the post (Fig. 4).
INSTALLATION
1. Install headrest clips to seat frame.
2. Place seat belt guide over outboard headrest guide post.
3. Install headrest into seat back.
NOTE: Ensure that the headrest engages completely into the posts.
4. Install the seat belt anchor plate and latch place through seat belt guide.
5. Insert seat belt latch plate into the seat belt buckle along the seat cushion.
Fig. 5:
NOTE: Prior to attaching seat belt anchor bolt, verify the seat belt webbing in not twisted (Fig. 5).
6. Install seat belt anchor bolt and tighten to 40 N.m (350 in.lbs.) torque.
7. Zip up the seat back zippers.
8. Engage hook and loop attachment at the lower edge of seat back.
9. Reposition seat.