Service Procedure

DISTRIBUTOR ASSEMBLY ILLUSTRATION:

1. Referencing applicable vehicle shop manual instructions (Section 6D), remove distributor cap, rotor and inspect distributor module. If part number code "908" appears on module (See Illustration) DO NOT replace distributor coil or module. Reassemble distributor and go to step (4).

2. If part number code IS NOT "908", replace distributor coil and module, per shop manual instructions, with standard output coil and module.

3. Regap Spark plugs to .035 inch.

4. Check and reset ignition timing to specifications as indicated on vehicle emission label.

5. Install spark plug gap revision label (P/N 10051463) provided with campaign bulletin. This label should be affixed beside existing emission control (tune-up) label. Additional labels can be obtained from your zone office.

6. Install Campaign Identification Label.
# Denotes Change

CAMPAIGN IDENTIFICATION LABEL:

CAMPAIGN IDENTIFICATION LABEL

Each vehicle modified in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label". Each label provides a space to include the campaign number, the five digit dealer code of the dealer performing the campaign service, and the date vehicle was campaigned. This information may be inserted with a typewriter or ball point pen. Install the label only on a clean, dry surface of the radiator baffle where it is readily visible. (Additional campaign labels are available on stationery order Form 7901-709.)