Programmer

Programmer Assembly & Temperature Valve Link:

REMOVE OR DISCONNECT

^ Disable Supplemental Inflatable Restraint (SIR) system, Refer to Air Bags and Seat Belts / Air Bags (Supplemental Restraint Systems). Air Bag Systems

1. Powertrain Control Module (PCM) from attaching bracket.

^ Let PCM hang, leave wires attached.

2. Vacuum and side electrical connector from programmer.

3. Temperature valve link rod.

^ Reach up through PCM bracket to gain access to rod.

4. Programmer attaching screws.

5. Temperature valve actuator connector.

^ Reach up through PCM bracket to gain access to connector.

6. Programmer

INSTALL OR CONNECT

1. Programmer in position.

2. Temperature valve actuator connector.

^ Reach up through PCM bracket to gain access to actuator.

3. Programmer attaching screws.

^ Tighten screws to 1.4 Nm (12 lb. in.).

4. Electrical and vacuum connectors.

5. Temperature valve link rod to air mix valve.

^ Reach up through PCM bracket to gain access to rod.

^ Adjust Temperature Valve Link Rod after installation, Refer to Temperature Valve Link Adjustment. Adjustments

6. PCM to bracket.

^ Enable SIR system, Refer to Air Bags and Seat Belts / Air Bags (Supplemental Restraint Systems). Air Bag Systems