Ignition Control Module: Service and Repair

Ignition Coil Assembly:

Ignition Coils And Module:

REMOVE OR DISCONNECT
1. Disconnect 6-way, 3-way and 2-way connector at ignition control module.
2. Remove spark plug wire harness from coils.
3. Remove (6) screws securing ignition coils to ignition control module.
4. Disconnect coils from ignition control module.
5. Remove ignition control module.

INSTALL OR CONNECT
1. Ignition coils to ignition control module.
2. Install (6) screws.

Tighten
Screws to 4.5 Nm (40 lb. in.)

3. Connect spark plug wires.
4. Connect electrical connectors.