4L60-E

REMOVE OR DISCONNECT
1. Raise and suitably support vehicle.
2. Vehicle speed sensor electrical connector.
3. Vehicle speed sensor bolt/screw (100).
4. Vehicle speed sensor (99) and O-ring seal (42).
- Use suitable container to catch any transmission fluid.

INSTALL OR CORRECT

NOTICE: Always use the correct fastener in the correct location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHER WISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on the threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Vehicle speed sensor (99) with new O-ring seal (42).
2. Vehicle speed sensor bolt/screw (100).

Tighten
- Vehicle speed server bolt/screw (100) to 11 Nm (97 inch lbs.).

3. Vehicle speed sensor electrical connector.
4. Lower vehicle.
- Check transmission fluid, add as required.