Theft Deterrent Arm/Disarm Customization

Theft Deterrent Arm/Disarm Customization Table:

IMPORTANT
^ If the ignition switch is moved to the "OFF" position while in the customization procedure, the theft deterrent arm/disarm customization procedure will be terminated and the system will remain in the most recent mode.

To customize the theft deterrent arm/disarm control features:
1. Remove the "MALL PGM" fuse from the fuse panel.
2. Turn the ignition to the "ACC" position. One to four bongs will occur to indicate which Body Control Module (BCM) version is installed on the vehicle.
3. Insert the door lock key into the door lock cylinder.
4. Rotate and leave the key in the unlock position.
5. Press the transmitter "Alarm" button. The seat belt telltale flashes and the chime will bong one to four times, equal to the current customization mode, to indicate which mode the vehicle is in.

Each time the transmitter "Alarm" button is pressed, the mode number will advance. A transition past mode four will repeat starting again at mode one. To exit and save the current customization, turn the ignition "OFF" and replace the "MALL PGM" fuse back into the fuse panel. If you desire to customize other features, customize them before reinstalling the "MALL PGM" fuse into the fuse panel.